Page 10 - WEB-I3 Insulating Glass Fabrication Supplies and Equipment

SECTION 2 FHC INSULATING GLASS FABRICATION, SUPPLIES, AND EQUIPMENT
FHC IG Fabrication Methods Bulk Quantities Available
Click to Chat With Us
Metal Spacer Insulating

Glass Units

This section is intended to serve as a guide Completing Spacer Frame
rather than a strict specification. As a Once the spacer frame is assembled, it’s
manufacturer, it is your duty to decide the time to fill it with a desiccant to prevent
variety of insulating glass units you plan to moisture accumulation. Store the desiccant
produce and accordingly tailor your design in a clean area to avoid contamination. Fill
and choice of materials and equipment, as the frame thoroughly before applying the
these decisions will substantially influence edge seal.
quality of the finished units.
To finalize the spacer frame assembly,
Start by determining the type of insulating securely attach the corners. Choose corner
glass unit you will manufacture, whether keys that match the size of your spacer
it will be a single seal or a dual seal to ensure a tight fit. Improper selection
unit. Then, select suitable spacers and or insertion of corner keys can lead to
desiccants for the units you intend to use. challenges during the assembly
process and may result in
Spacer Frame Construction deformation of the frame over
Spacers should generally be cut to a length time. Once these steps are CORNER KEY
that is a minimum of 7/8" (22 mm) shorter complete, you are ready
than the glass length, to accommodate to begin assembling the
for sealant application and the overall insulating glass units.For
dimensions of the glass. The exact length assistance or questions,
may need to be adjusted depending on contact our Technical
the spacer’s width; wider spacers may Representatives at SPACER
require a larger adjustment. Ensure the (888) 295-4531 or via email at
spacer is set back from the glass edge to Sales-Support@fhc-usa.com.
allow for an even application of sealant. If
a consistent set-back is not possible on all
sides, you may need to adjust the spacer
frame. Handle spacers with care to avoid
transferring any oil or contaminants from
your hands. Use a fine-tooth saw blade and
an oil-free solvent to clean the ends after
cutting. Make sure there are no burrs on
the spacers so that corners can be fully
inserted for a snug fit.

FHC Tungsten Carbide
Tipped Saw Blades

- For Thin Wall Aluminum Extrusions
- 10" and 12" Available

ITEM NO. DIAMETER ARBOR NO. OF TEETH
SB10 10" 5/8" 100
SB12 12" 5/8" 120
Minimum order: 1 each.

Visit fhc-usa.com to search for
THE GLAZING SUPPLY COMPANY Metal Spacer
Enter the Item Number or scan QR code with
IG10 EXPERIENCE A ND INNO V A TION your smartphone for complete product details