Page 11 - WEB-I3 Insulating Glass Fabrication Supplies and Equipment

FHC INSULATING GLASS FABRICATION, SUPPLIES, AND EQUIPMENT SECTION 2
SECTION 2
FHC IG Fabrication Methods Bulk Quantities Available
Click to Chat With Us

FHC Silicone

Foam Super

Spacer Notcher
®

- Hand-Held Pneumatic Tool for a Continuous Process
- Space Width Adjustment Can Accommodate
Sizes from 3/16" to 15/16"
- Fixed Setback Distance for
Straight-Line Application
- Circular Punch for Corner Notching
- Cutting Blade or Final Spacer Cut-Off

ITEM NO. QSSPN1
Pneumatic Notcher

1. Once the liner is stripped from the Super Spacer, with the foil 6. Glide the tool along the glass edge until the next corner is
surface facing the operator, insert spacer into the notcher reached. Press the notcher punch trigger to activate the
shuttle tool between the pressure wheel and the guide roller notcher punch
2. To load, pull the spacer through so that it extends beyond the 7. Continue moving the tool straight ahead until the left side of the

pressure wheel and parallel to the base of the tool. Once the notch is aligned with back edge of the faceplate. Press down on
cutting blade is engaged and you’re ready to notch a corner, the spacer to ensure good adhesion
activate the punch trigger
8. Tack down spacer at about 1" distance from the corner. Proceed
3. Position the spacer so that the bottom spacer edge exceeds the with spacer application, repeating steps at the second and
tool base by about 1/32" third corner
4. Place the guide block against the side of the first glass lite and 9. At a point approximately 1" from the final corner, guide the tool
align with the starting corner of the glass. Once aligned, tack slightly outward to avoid hitting the starting end of the spacer.
down by applying pressure Notch and cut off the spacer end and remove tool by pulling it
forward and off the previously applied spacer
5. Support the spacer tape slightly above the glass surface. While
maintaining the tape perpendicular to the glass, apply slight 10 Manually align the spacer ends to form the final corner joint
downward pressure and glide the tool along the glass edge
toward the second corner For videos and the complete instructions visit fhc-usa.com.

ATTENTION: The FHC Super
Spacer contains a desiccant
®
A. B. C. and must not be left out in
CORNER CORNER the open air for any duration.
CUT-OUT CUT-OUT
GLASS GLASS GLASS
Ensure that any material not
immediately used is repacked in
SPACER SPACER SPACER
the provided foil bag and then
securely stored in a Ziplock bag
Typical Corner Notch or a similar container that is
hermetically sealed.
Finished Corner
Super Spacer is a registered trademark of Quanex Building Products Corp.
V
Visit fhc-usa.com to search for
com
to search f
or
isit
f
hc-usa.
Keyword FRAMELESS HARDWARE COMPANY LLC
Super Spacer
4361 Firestone Blvd. South Gate, CA 90280
Enter the Item Number or scan QR code with Toll Free: (888) 295-4531 | Direct: (323) 968-2031
Enter the Item Number or scan QR code with
our smar
your smartphone for complete product details IG11
y
or comple
te produc
tphone f
t de
tails
Fax: (323) 336-8307 | fhc-usa.com